Keep Weather Outside Where It Belongs

Metal and shingle roofing installation in Colbert

Your roof protects everything under it, and when shingles lift, metal panels leak, or flashing fails, water finds its way into walls, ceilings, and insulation faster than most homeowners expect. Homes in Colbert face heavy snow in winter, wind during seasonal transitions, and rain that tests every seam and fastener on your roof. If your roof is aging or showing signs of damage, waiting usually means paying more to fix what water has already reached.

McDonaldNSonsDecks installs and replaces both metal and shingle roofing systems with attention to proper flashing, ventilation, and safety protocols that come from hands-on experience in exterior construction. Whether you are planning an addition, replacing an aging roof, or upgrading materials during a remodel, the work follows the same standards used on new builds. Each project is backed by full licensing and insurance in Washington, and communication stays clear from material selection through final inspection.

If you need roofing work done right in Colbert, reach out to discuss your project and get a clear timeline.

How metal and shingle roofs get installed

Roofing projects in Colbert start with removing old materials if necessary, inspecting the roof deck for damage, and addressing any issues with sheathing or framing before new roofing goes on. Metal roofing is installed with fasteners designed to handle expansion and contraction, and panels are overlapped and sealed to prevent water intrusion. Shingle roofing is layered starting at the eaves with proper underlayment, flashing around vents and chimneys, and ridge caps that seal the peak.

When the work is done, you will see clean lines, no gaps around penetrations, and a roof that sheds water and snow without pooling or leaking. Metal roofs will sit flat without waviness, and shingles will be aligned and secure without lifting at the edges.

Ventilation is checked to prevent moisture buildup in the attic, and flashing is installed correctly around chimneys, skylights, and roof-to-wall transitions. This is not cosmetic work but structural protection that keeps your home dry and intact through years of weather exposure. Safety equipment and protocols are used on every project, and the site is cleaned thoroughly once roofing is complete.

Questions that come up during planning

Homeowners in Colbert often want to know the difference between metal and shingle roofing, how long installation takes, and what kind of maintenance each material requires over time.

What is the difference between metal and shingle roofing?
Metal roofing lasts longer and handles snow load well but costs more upfront. Shingle roofing is less expensive and easier to repair but may need replacement sooner depending on weather exposure.
How long does a roof installation take?
Most residential roofing projects in Colbert take three to seven days depending on size, pitch, and material. Weather can extend the timeline if conditions are unsafe for roofing work.
What gets checked before new roofing goes on?
The roof deck is inspected for rot, sagging, or damage from leaks. Any compromised sheathing or framing is replaced before new roofing material is installed.
How is flashing handled around chimneys and vents?
Flashing is installed to direct water away from roof penetrations and prevent leaks at seams. Metal or composite flashing is used depending on the roofing material and the type of penetration.
What kind of maintenance does a new roof need?
Metal roofs need occasional cleaning and fastener checks. Shingle roofs should be inspected after heavy storms and cleared of debris that can trap moisture and cause damage.

If your roof in Colbert is past its prime or you are adding onto your home and need reliable roofing work, McDonaldNSonsDecks brings the experience and attention needed to keep your home protected for years.